It’s been a few weeks since I posted anything, I had to take a little break on projects around here and head over to Nevada to put some equipment into a datacenter. Anyway, soon as I got back, I got on the truck project.
First up was a trip to the tool store, where I picked up a handy new item for the shop, a sandblasting cabinet. I have to say after playing with it a bit, it’s one of the most useful toys tools I’ve bought. You can pretty much make anything look new.
Half sandblasted fan
Power Steering pump with cleaned up brackets
First thing the truck needed was a new power steering pump. The steering was working, but at low RPM’s like in parking lots it got a little tough to move the wheel. Power steering pumps are pretty cheap for this year of truck, so I sprung for the one with the new reservoir. While I was at it, I took apart all the brackets and mounting hardware, and ran it through my new sandblaster. The problem was, now one side of the engine was all shiny looking and the other was looking pretty, well, old. I had already decided to replace all the belts, and the alternator had a little fray on the primary cable so I decided to take that all apart as well.
Cleaned up and assembled.
While I was waiting for the multiple coats of paint to dry, I decided to do a tune up, so I ran down and got some plugs. The cap and rotor looked almost new, and this year of truck had electronic ignition and no points. I picked up a new air filter at the same time. While pulling the plug wires off the plugs, a few of them were rusted to the plugs because the previous owner didn’t use dielectric grease, so I wound up destroying a few of the wires. Ultimately, I’ll buy a custom set of red wires for it, and cut them all to length so they look better in the looms, but for now I just grabbed some cheap silver ones to get running again.
New wires, painted coil
The plugs all looked great when I pulled them out. Normal wear and tear, slightly larger gap than spec. I replaced em with platinums. I found the coil was kind of flopping around on its mount, so I took that apart too and sandblasted it and painted it up, then secured it better to the intake manifold.
